LCD Display Wire And Cable Bending And Torsion Tester With Max Load 10KG

Product description:

Wire and cable bending and torsion tester is according to pre-set test conditions (bending angle, bending rate, number of trials), with a continuously make test sample right and left bend durability test device and straight line torsion durability test equipment through an external mechanical device. Wherein the fixture terminals of torsion test and bend test are using one common drive shaft, simply replace φ100

three-jaw chuck and bending test apparatus.

 

Standards:

• JIS, JEC, JEM, etc.

 

Technical parameters:

Bending test parameters:

• Max load: 10KG

• Maximum permissible moment: 16Nm

• Rocking rate: 5 to 90 round trip / min

• Bending angle: 0 to less than ± 180 ° (angle adjustable)

• Times of test: 0 to 9999999 times

• Wheel: φ 100mm, 1 pcs

• Bending radius: R10, length 100mm, spacing adjustable range 0 ~ 50mm

• Clamping fixture: holder holding width range of 45mm

• Stopper fixture: spacing adjustable range 0 ~ 50mm

 

Torsion test parameters:

• Twist angle: 0 ~ ± 270

• Twist rate: 5 to 90 round trip/min

• Times of test: 0 to 9999999 times

• Clamping fixture center height: 1056mm

• Distance between clamping fixtures: 0 ~ 1000mm

• Sliding clamp stroke length: 100mm

• Fixed fixture: ø80mm three-jaw chuck, clamping range 2 ~ 80mm

• Sliding fixture: ø80mm three-jaw chuck, clamping range 2 ~ 80mm

 

Specifications:

• Overall dimensions: 2000mm × 550mm × 1400mm

• Power supply: AC220V, 50 / 60Hz 2A